Organic Syntheses, Coll. Vol. 1, p.94 (1941); Vol. 1, p.33 (1921).
In a 3-l. round-bottomed flask (Note 1)
fitted with a reflux condenser
are placed 625 cc. of 95 per cent alcohol (Note 2)
, 500 cc. of water, 500 g. (476 cc., 4.7 moles) of pure benzaldehyde (Note 3)
, and 50 g. of sodium cyanide (96–98 per cent)
. The mixture is then heated and kept boiling for one-half hour (Note 4)
. In the course of about twenty minutes, crystals begin to separate from the hot solution. At the end of the thirty minutes, the solution is cooled, filtered with suction, and washed with a little water. The yield of dry crude benzoin
, which is white or light yellow, is 450–460 g.
per cent of the theoretical amount). In order to obtain it completely pure, the crude substance is recrystallized from 95 per cent alcohol
, 90 g.
of crude material being dissolved in about 700 cc. of boiling alcohol
; upon cooling, a yield of 83 g.
of white, pure benzoin
which melts at 129°
The reaction sometimes takes place with considerable violence and material may be lost through the condenser. Accordingly, a somewhat larger flask is generally desirable, or the upper end of the reflux condenser is provided with a wide tube leading to an empty flask.
The procedure described requires 50 per cent
of the amount of dilute alcohol
which is ordinarily recommended in the literature. This allows one to prepare just double the amount of material in the same sized flask. The product obtained in this way, however, is slightly yellower than that obtained when more alcohol
is used, but upon recrystallization it gives just as pure a product as that obtained by recrystallization of crude material made in the presence of more solvent. The results of many experiments lead to the conclusion that, if large amounts of benzoin
are to be prepared, the method described above is the better one. If, however, only a small amount is needed and a good grade of crude material is satisfactory, the larger amount of solvent is perhaps more desirable.
It is absolutely necessary that pure benzaldehyde
be used for this reaction. The crude benzaldehyde
which is obtained on the market should be washed with sodium carbonate
solution, dried, distilled with minimum atmospheric exposure, and a fraction collected at 178–180°. Crude material will never give much more than a 50
per cent yield of benzoin
Several times when benzoin
was being prepared, the condensation took place and was complete after boiling five to ten minutes or even less,
the product separating out in the hot solution with evolution of heat. The yield under these conditions was always good and the color better than when the reaction took a longer time. The cause of this occasional rapid reaction was not discovered, but it was probably due to inoculation with a little benzoin
in certain of the experiments. When it takes place as just described, the flask and efficient condenser used will be sufficient to condense the sudden, rapid evolution of alcohol vapors caused by the heat of crystallization of the benzoin
This preparation is referenced from:
Copyright © 1921-, Organic Syntheses, Inc. All Rights Reserved