Organic Syntheses, Coll. Vol. 1, p.15 (1941); Vol. 6, p.1 (1926).
The apparatus is assembled according to Fig. 1. B and D are 5-l. round-bottomed flasks
, immersed to about two-thirds of their height in deep oil baths
heated by large burners
. Each bath is provided with a thermometer
reaching to the level of the bottom of the flask. Flask B is fitted with a specially treated two-holed cork stopper (Note 1)
, in one hole of which is fitted a 500-cc. separatory funnel
A and in the other a delivery tube C of 12-mm. diameter
. The tubes must not extend more than 3 mm. below the stopper. Flask D is fitted with a three-holed cork stopper
connected with a separatory funnel, the delivery tube from B, and the delivery tube E of 12-mm. tubing leading to flask F. F is a 500-cc. round-bottomed flask
immersed to two-thirds of its height in an oil bath heated by a Bunsen burner
and provided with a thermometer.
Flask F is provided with a two-holed cork stopper connected with tube E, and with tube G which connects with the first condenser
H and may be of smaller bore than tubes C and E. H is a condenser with a 30-cm. water jacket
. H is connected with I by means of an adapter
. I is a 1-l. round-bottomed flask
supported in a pan
which is at first filled with ice and later used as a water bath
. Flask I is fitted with a two-holed cork stopper carrying the adapter connected with condenser H and a Vigreux column K of 2-cm. diameter and a length of 30 cm. to the side arm.
Flask I and condenser H are covered with black cloth (Note 2)
. The side arm of K is connected with a 90-cm. water-jacketed condenser
L which leads into M through an adapter. M is a 750-cc. Erlenmeyer flask
immersed in an ice bath
. Flask M is provided with a two-holed stopper connected with the adapter from L and an upright bulb condenser
that is provided with a tube leading through a window or to a hood
Before the final assembling of the apparatus, the flasks are charged as follows: One kilo of freshly fused and finely powdered acid potassium sulfate
, 200 g. of powdered potassium sulfate
, and 300 g. (238 cc.) of dry glycerol (Note 3)
are thoroughly mixed in each of flasks B and D. In each of flasks I and M is placed about 1 g. of hydroquinone
to act as a stabilizer for the acrolein
The apparatus is assembled as indicated and the oil baths under B and D are heated to about 190–200° (Note 4)
, and the oil bath under F to about 110–120°. The bath under I is filled with ice. The volatile products are collected in I which is kept carefully protected from light. When the reaction is well started 300 g. of dry glycerol
is placed in each separatory funnel, and added drop by drop during the heating. After the first violent reaction has abated (about one hour) the baths under B and D are raised to 215–230° and maintained there until no more volatile product comes over (a total time of heating of about four and one-half hours). After B and D have been heated about four hours the ice under I is replaced by water which is heated to 75–80° to distil the acrolein
into flask M, which is packed in ice. Near the end of the distillation the water under I is heated to boiling.
The product in M is treated with small amounts of solid sodium bicarbonate
to neutralize any acid present. The cold liquid is filtered through a small filter
into a 1500-cc. distilling flask
containing about 1 g. of hydroquinone
. It is then distilled into a tared dark bottle
containing about 1 g. of hydroquinone
. The yield of product boiling at 52.5–55.5° (Note 5)
obtained from 1200 g. (13 moles) of dry glycerol
is 240–350 g.
per cent of the theoretical amount).
used in the apparatus are made tight and heat-resistant by treatment with sodium silicate
solution. After being properly fitted and bored they are placed in the silicate
solution contained in a bottle that is connected with a suction pump
. The solution is forced into the pores of the corks by alternately making and breaking the reduced pressure and shaking the solution vigorously. After the excess of solution has been wiped off, the corks are put in place while still wet. After this the outside of each cork is given an extra coat of the silicate
solution. When corks treated in this way were used no odor of acrolein
was noted in the laboratory.
has pronounced lachrymatory properties and is also highly toxic.
The exclusion of light slows up the polymerization of the acrolein
. If the condensers are not protected from light a solid polymer collects in them.
is dried by heating slowly in an open dish
in a hood until the temperature of the liquid is 170°. A sand bath
is used and the heating requires about three hours. "Dynamite glycerine," 96–98 per cent
, may be used instead of the dried glycerol
The heating must not be too rapid nor too high at first as there is danger of frothing followed by a clogging of the apparatus.
Copyright © 1921-, Organic Syntheses, Inc. All Rights Reserved